Universal Radial 6380 series CLINCH IN sensor light is off, how to solve?
CLINCH IN sensor light does not light up
Phenomenon: After the foot trimmer completes the foot trimming action, the CLINCH IN sensing light does not light up, and the machine stops and does not move
Reason: Due to the excessive height adjustment of the foot clipper, the position of the sensor is relatively offset, and the machine cannot sense normally, so the CLINCH IN sensing light does not light up
Solution: Adjust the position of the CLINCH IN sensor again. Keep the machine in a cropped state and move the sensor up to the CLINCH IN light
Slowly move the area that is not lit down to the position where the light is just lit and then lock it again. Pay attention to maintaining the gap between the two and the top rod of the cutting foot, so that they do not touch each other